pulled my GF's 2.4 ecotec after a frozen PCV tube blew out the rear main seal . pulled from the top , cleaned out the plugged hole in the intake etc . now that it's all back in place it will crank but not start . cheap OBD scans 2 codes po113 and p2228. any thoughts ??
pulled 2.4 ecotec to repair rear main seal , now cranks but wont start
- Thread starter jbon64
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
