I was noticing that the exhaust timing was not changing in my diagnostic scanner. I replaced both Exhaust Camshaft actuator solenoids (Bank 1 & Bank 2) and the P0017, P0019, and P0024 errors went away. I can now see the exhaust timing change.
I'm still having some issue that I'm trouble...
I put the Old / original PCM in and it started, no codes. After warming up a bit, I get O2 sensor errors. Then once it is warmer and starts to run rough, I get Crank & Cam sensor errors:
There are 7 issues for Power system：
P0017-00 Crankshaft Position - Exhaust Camshaft Position Not...
Started it back up today, still get the odd issue when it gets warm, the engine dies. Someone w/ their Chevy had a bad transmission (overheating) that was causing their engine issues. I plugged my Launch diagnostic tool in and went into transmission data and temps are all good, no faults. I...
I'm working on a 2010 Chevy Equinox LTZ with 3.0L. I do not know the entire state of the engine before working on it. It has 178k miles on it. Initial issue I'm aware of was it was in limp mode, and low oil pressure. Oil light was on, Check Engine Light was on, Service Stabilitrak notice...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
