Reply to thread

Message: <blockquote data-quote="rawhite318" data-source="post: 29181" data-attributes="member: 8903">ill explain what I did but first Ill tell you what I wish I knew before I did what I did. this is what I would have used for my car if I went this route. <a href="https://axxessinterfaces.com/product/AXDSPX-GL10" target="_blank">https://axxessinterfaces.com/product/AXDSPX-GL10</a>. It is far easier to install but will still run about $300. What I did was bought this. <a href="https://www.crutchfield.com/p_161DM810/AudioControl-DM-810-Digital-Signal-Processor.html?tp=61658" target="_blank">https://www.crutchfield.com/p_161DM810/AudioControl-DM-810-Digital-Signal-Processor.html?tp=61658</a>. but I had to make my own wiring harness for it  by interrupting  the wires going to the amp and feeding them into the audiocontrol then bringing the wires from that to the amps I purchased and then run those wires to the factory harness to the speakers. The process is the same for both. but with the wiring harness there is nothing extra to mount. just the amps. either way if that sounds like to much to f with then bring it to a pro installer but do your research.  like PoManNox said in a round about way there are some stupid lazy people out there.  I myself don't mind a fuse tap but I know where and when to use them.edit. I just realized that with the axxcess harness you don't have to take the steps I did because rca's are built into the harness.another edit. call axxcess and make sure that's the right harness for you. I guess the Canadian plant uses a different harness than the one in Mexico. also my car didn't have the Bose system so that probably makes a difference.</blockquote>

Verification