Search results

I would check to see if the ac compressor is engaged when the ac is on. If it is not engaged then maybe the cable that goes to the compressor that activates the clutch is either damaged or just not connected to the compressor. I have the 3.6 V6 and the ac compressor is right by where the...

You are not getting any other codes that may be indicating a lean condition - like a P0171? Do you have a scan tool that can look at the long and short term fuel trims to see what they are at idle when this rough idle issue is happening? If you are saying the car runs fine when the engine is...

Is the A/C working at this point meaning the compressor is running and it is blowing cold? If yes, then probably there is no leak but the dye method with the UV light or using a leak tester is the best way to go with that to make sure. If you have not done so you should check your cabin air...

If you mean an Electronic Brake Control Module (EBCM) for your ABS system, I believe that is something that does not need programming. Now if you mean the body control module (BCM), then yes you need to have that programmed as you said. You need a high end scan tool like a Tech 2 or higher end...

Interesting video. I have tried the manual mode using the up/down on top of the shifter and I just could not get into using it myself. it just felt weird to me being able to shift gears with no clutch needed like a manual but again that is just me. I think others would really like to know...

Does the noise change when on different roads? Sometimes when on concrete roads I get noise but I would not call it drivetrain noise - more like tire noise perhaps. Then you go to asphalt paved roads and the car is much quieter. Does the noise change (better/worse) when turning right or left...

For a service manual you can go to helms manuals. You can get the real factory service manual from them in Printed form or on USB https://www.helminc.com . It is not cheap but that is a place to go. Alldata subscription is a good choice as well. I have Alldata at work and like the others...

If that work was not done already perhaps your hub bearings are going bad especially if you have high mileage on the car. You should check each wheel for excessive play which could give a clue as to which if any of the bearings may be bad.